Home Improvement Ideas

Kitchen-sink-drain-installation-instructions, if your kitchen sink drain is corroded and leaking, installing a new basket strainer is an easy way to solve the problem. start by adding plumber’s putty to the underside of the basket strainer and fit it into the drain hole at the bottom of the sink. then, tighten the nut with a basket wrench to secure it in place.. Wrap the plumber's putty around the edge of the drain hole in the kitchen's sink. tear off any part of the putty that overlaps the rest, making sure that the same amount of putty sits around the entire opening. step 3 lower the sink's drain down into the drain opening., learn to install a new kitchen sink with our easy-to-follow video and guide. in just a few steps, you can breathe new life into your kitchen. table of contents. prepare for the new kitchen sink. remove the old sink. install the new sink..

How to install a kitchen sink drain. replacing your sink is a step-by-step process. in today’s post, we’ll discuss the method for installing a kitchen sink drain. this process should be relatively easy for anyone with diy plumbing skills. if you’ve never done your own plumbing before, we recommend starting with a project that’s a little ..., virtually all kitchen sinks sit on a countertop, so cutting a hole for the sink is an essential part of the job of installing one. installing the faucet and drain are also important procedures. most sinks come with clips or connectors and instructions for using them. read the instructions carefully..

Instructions check the drain outlet height if you're planning to replace a standard sink with a deep-basin sink, you may need to lower the drain fitting in the wall to match the lower height of the new sink drain. before you buy a new kitchen sink, it is a good idea to check the height of the trap arm on the old sink., how to replace a kitchen sink drain. step-by-step instructions. think about all that your kitchen sink endures on a daily basis. you put it through a lot of wear and tear, don’t you? at danco, we make parts that make it easy and relatively inexpensive to restore your fixtures to like new condition without replacing the entire kitchen sink, so ....

Feed the faucet's supply tubing and tailpiece through the gasket that seals the faucet to the sink and then up through the hole (or holes) in sink. screw the mounting nuts and washers to the underside of the sink deck. make sure the faucet can swing in a full arc across the sink before tightening mounting nuts. attach strainer., if you are replacing the sink along with the sink strainers, it is easier to replace the strainers before you set the sink..

Use 16-in. slip-joint pliers or spud wrench to unscrew the kitchen sink strainer locknut. if the entire basket spins, insert the handles of a pliers into the strainer grate from above and stick a screwdriver between the handles to hold it still. reach over the front of the sink, or have an assistant hold the screwdriver from above. if you can ...